Separate names with a comma.
It is just a "Bang" after WOT,and lifting my foot quickly. And the muffler bellows out. And not a backfire every time (it happened three times...
Sounds like the relay is going click. It may be on the firewall,the ones on the earlier wagons are there. As I have mentioned before,often it is...
Power Brakes OK,must not be a vacuum issue. The engine backfires through the exhaust,another muffler destroyed. Not so much buggity buggity...
The early '60s 3rd seat setup is a bit different from my old '56 Ford. Oh well,nice to see how they did it.
Not so bad if it goes "Thud",as long as it doesn't go "Bang!" So,I was 90 miles away for the Easter weekend and I stopped in at a garage I'd seen...
I'd prefer an F-105D,but my eyesight kept me out of the Air Force! The '73 drinks fuel like an F-105,so I'm partway there. Anyway,today I ripped...
The Country Squire lifestyle assumes that you have a garage and maybe a chauffeur/footman,one of whom will hang the seat cushion and seatback on a...
So today I received the vacuum modulator & installed it on the C6. The return goes to EGR port on the carb. Of course,new rubber parts,etc....
Well,OK,why wouldn't engineers confuse us? Why NOT have the same code mean two different things? Cheez Whiz!
Yeah,if you could find one,you're set up for one. It's just like a '56 Ford would have. But since 3rd seats were removable,folks would lose them....
Again,my issue with the transmission mix-up was that in FACT the data plate says "U" code C6,whereas the build sheet says "C4" in the transmission...
So I tried a bunch of different "Turns" settings on the vacuum advance. Engine seemed to run OK,then horribly. Gap/timing/dwell are set. Today I...
Ford parts counter got me a vacuum advance. There are many adjustments for different car model lines,and the fact sheet only goes up to 1971. I...
I've had four--an '85,'86,and an '89 white wagon which was the best,even though it was the worst parts hog ever (Gas tank,Oil pan--who ever...
Not as much lube as there was,but some. The vacuum advance they sold me was unsuitable--the applications were only up to 1971. It'd be nice to...
I overlooked the right side upper control arm bushing--I had the left one done,now the right side one is completely gone. I have the part,Ford...
I can't understand how the point gap shrinks like that! Well,I didn't set it,so they could've set it wrong when they did the timing chain job....
The salvage yard is Balicki's in Palmer,MA. They have a website. If you get there,it's probably better to park and walk in.
So,anyway,today I dug a little deeper underhood. Somehow the points gap shrank to like .009. Why does this always seem to happen? So I reset it. I...
In 1983/1984,I pulled all parts myself. They are a lot more crowded now,I don't know what the rule is. If I knew where you were,we could see if...
