Separate names with a comma.
Wagonrodder, I actually got a new tank from Auto city Classics and so far it is a direct fit. It is a bit smaller dimensionally and hold about a...
She is out! Rolled her out today minus a few things, so she will go back up on stands for a bit. Here she is and the dirt I washed out of her...
Hard launches in a wagon...with just a 312/4bbl:whistle::whistle:. I just bolted the diff down to the springs w/o the rubber/plates but I used the...
Got new rear springs and the diff in place on sunday. Hoping to add brakes over the next two days, drop the engine off at the rebuilder and then...
Well since the car did not come with any of these pieces I probably will just go back to the way it came. As in no rubber and just the axle on the...
Ok, got the diff and new springs in. According to the manual it should diff, metal spacer holder, rubber spacer, spring, rubber spacer, metal...
Who knows. Got it from a yard so it is anybodys guess. Either way she is going into the shop and I am hopin not a lot of work needs to be done...
In preparation to take the block and crank to the builder I tore down the rest of the engine today. Not all that bad actually. The cylinders and...
On the brake adjusters, I gave up as I can’t use them on the front brakes. I looked at them backing plates and discovered that the adjusting holes...
Well, replaced the axle seals in the diff and am getting ready to hang it with new springs this week. Front end is done minus the sway bar (trying...
Old Fox, you are correct and I asked at NAPA where I got them and he said that is how they are making them now. Now I have to figure out if i have...
One wheel down one to go tomorrow and then the front brakes and suspension will be done-minus the sway bar. I put self adjusters on both fronts...
Yeah, sure beats it completely grenading out in the middle of nowarsville.
Well….I was going to give Tim McMaster my cam as a core when I pick up the heads next month. Now I am going to give home the whole engine instead....
I temp installed the PS components today and it looks like everything is going to function properly. I just need to know how to tell which long...
I will be following this as I have to replace all of the seals in my 57 wagon. I know Dennis Carpenter reproduces the 1/4 window gaskets. We may...
Yep. I could not twist it by hand at all and that was with the tie down bolt out. I tried tapping-very gently with a hammer to see if it would...
If at first you don’t succeed, use a bigger F’ing tool! Got the distributor out-not happy about how I did it but it is out and in one piece. Also...
PS steering components are getting new bushings as I apparently had them installed backwards. Got new KYB shocks that fit like a glove without...
Installed front springs and control arms. Later this week I will install the PS components and finish the front brakes in preparation for...
